Arduino Plug & Play
- •Controller: Arduino UNO/Nano compatible (ATmega328P), 5V logic
- •Interfaces: Digital I/O, PWM, Analog In, I2C/SPI/UART
- •Plug-and-play sensor ports (JST/RJ/3-pin)
- •Power: USB 5V / DC 7–12V (if UNO).
Description
Controller: Arduino UNO/Nano compatible (ATmega328P), 5V logic. Interfaces: Digital I/O, PWM, Analog In, I2C/SPI/UART. USB programming. Plug-and-play sensor ports (JST/RJ/3-pin). Power: USB 5V / DC 7–12V (if UNO).
🔹 Key Features
- •Controller: Arduino UNO/Nano compatible (ATmega328P), 5V logic
- •Interfaces: Digital I/O, PWM, Analog In, I2C/SPI/UART
- •Plug-and-play sensor ports (JST/RJ/3-pin)
- •Power: USB 5V / DC 7–12V (if UNO).
🔹 Pin Configuration & Wiring
Pin 13 (SCK)
Connected directly to onboard yellow LED and SPI hardware clock bus.
pinMode(LED_BUILTIN, OUTPUT);
digitalWrite(LED_BUILTIN, HIGH);🔹 Applications
This component is engineered and suitable for:
- •Microcontroller interfacing (Arduino, ESP32, Raspberry Pi, STM32)
- •IoT telemetry, environmental monitoring, and smart home systems
- •Robotics navigation, obstacle detection, and motion sensing
- •STEM education, university electronics labs, and maker prototyping
🔹 Package Includes
- ✓1 × Arduino Plug & Play
Wholesale Tiered Pricing
Autonomous 4WD AI & Obstacle Rover Kit
Build a complete 4-wheel drive robotics rover with ultrasonic distance sensing & motor driver control.
Related products
Complementary hardware and compatible components for your project
IOT Plug & Play
MCU: ESP8266/ESP32 based (Wi-Fi 2.4GHz). Supply: 5V input, onboard 3.3V regulation. Protocols: MQTT/HTTP. Cloud/App support. GPIO with pre-wired ports. Typical sensors: DHT11/22, LDR, relay module, IR, PIR.
Snap Circuit Kit
Circuit modules with snap connectors. Power: 2×AA / 3×AA / 9V (kit dependent). Components: switches, LEDs, buzzer, motor, resistors, capacitors. No soldering. Safe low-voltage learning.
Breadboard Kit
Breadboard: 400/830 tie-points. Jumpers: M-M, M-F. Common parts: resistors (¼W), LEDs, push buttons, potentiometer. Modules: LDR, buzzer, IR, PIR, relay. Power module: 3.3V/5V rails (optional).
Roboki
Mechanical parts kit: beams, brackets, shafts, bushings, gears, pulleys, wheels. Materials: ABS/nylon/metal mix. Build type: screw/slot. Concepts: gear ratio, torque, linkages. Compatible with DC/servo mounts.
Paper Circuit Kit
Conductive copper foil tape. Power: 3V coin cell (CR2032). Components: LEDs (3mm/5mm), push switch, battery holder. Use: series/parallel circuits on paper. Safe low-voltage.
Only 2 leftRobotic Arm Kit
DOF: 3–6 (kit dependent). Actuators: servo motors (SG90/MG90/MG996R class). Control: Arduino/servo driver (PCA9685 common). Supply: 5–6V for servos (separate recommended). Payload: light (50–200g typical for small kits).
